HOME PROFILE PRODUCTS SPECIFICATIONS QUALITY MAINTENANCE FEEDBACK
           
       
 
     
Typical Cases of Premature Service Failure- Its Causes And Remedies
Sides of the belt are worn.
Remedy
Cause
Constant Slip Re-tension the drive until belt stops slipping
Misalignment Realign Sheaves
Worn Sheaves Replace with new Sheaves
Incorrect Belt Replace sheaves with new correct belt
   
 
Bottom And Side are burned
Remedy
Cause
Belt slipping under starting or stalling load Replace belt and tighten drive until slipping stops
Worn Sheaves Replace Sheaves
   
 
 
Bottom of belt are worn.
Remedy
Cause
Belt slipping, causing heat
built-up and gradual hardening
of base rubber compound
Install new belt. Tension to prevent slip.
Idler installed on wrong side
of the belt
Change the position of the idler
Improper Storage
Improve the storage condition.
 
Belt turns over and runs
Remedy
Cause
Foreign materials in groove s Remove materials/ shield drive
Misaligned sheaves Religion the drive
Worn sheave grooves Replace sheaves
Tensile member broken through
improper installation
Replace with new belts
Incorrectly aligned idler pulley Carefully align idler.
Check alignment with drive loaded and unloaded.
 
Bottom of belt are worn.
Remedy
Cause
Extreme shock load Remove cause of shock
Belt coming out of the drive Check drive alignment, foreign
material in drive.
Ensure proper tension and drive alignment.
     
 
   
 
 
 
       
  © 2008 Classic Belts Private Limited. All Rights Reserved.           Powered by Orica Technologies